Select language: En
0
2013
Impact Factor

    Bavo Langerock

    Hoogstraat 51, B9000 Ghent, Belgium
    Department of Architecture, Sint-Lucas Visual Arts, Institute for Higher Education in the Sciences and the Arts

    Publications:

    Ciocci M., Malengier B., Langerock B., Grimonprez B.
    Towards a Prototype of a Spherical Tippe Top
    2012, Vol. 8, No. 2, pp.  391-425
    Abstract
    Among spinning objects, the tippe top exhibits one of the most bizarre and counterintuitive behaviours. The commercially available tippe tops basically consist of a section of a sphere with a rod. After spinning on its rounded body, the top flips over and continues spinning on the stem. The commonly used simplified mathematical model for the tippe top is a sphere whose mass distribution is axially but not spherically symmetric, spinning on a flat surface subject to a small friction force that is due to sliding. Three main different dynamical behaviours are distinguished: tipping, nontipping, hanging, that is, the top rises but converges to an intermediate state instead of rising all the way to the vertical state. Subclasses according to the stability of relative equilibria can further be distinguished. Our concern is the degree of confidence in the mathematical model predictions, we applied 3D printing and rapid prototyping to manufacture a «3-in-1 toy» that could catch the three main characteristics defining the three main groups in the classification of spherical tippe tops as mentioned above. We propose three designs. This «toy» is suitable to validate the mathematical model qualitatively and quantitatively.
    Citation: Ciocci M., Malengier B., Langerock B., Grimonprez B.,  Towards a Prototype of a Spherical Tippe Top, Rus. J. Nonlin. Dyn., 2012, Vol. 8, No. 2, pp.  391-425
    DOI:10.20537/nd1202013

    Back to the list